Above the filter is the factory oil pressure sending unit, take off the connector and remove the unit.
I went to NAPA, got a brass 1/8 NPT T, and a 1" NPT thredded brass tube. I installed both to that because both oil pressure sender factory or aftermarket can not share the same circut.
My friend just used the factory oil pressure sending mount and some electrical tape to cover the oil light. Crafty, but yet lame right?
Look what they have in 1/8th in NPT fittings where ever you go, although you might need some different setup for your vehicle. Should not cost more that $5.00.
And teflon tape!
Bookmarks