you dont have to run parallel or bridge nething just run them straight to the amp....run ur fronts into channel 1 and 2 and ur rears into channel 3 and 4....when ur adjusting the amp set the frequencies to half to start and then move from there...ur gunna set ur rears louder than ur fronts by a little bit so the sound evens out....pretty simple....
When ur wiring ur crossovers ur gunna cut the plug off the speaker connector in the door and strip those wires...connect those two wires, knowing which is pos and neg if you dont then test them, to the inputs to the left of the crossover....then u run the wires from the mid bass speaker to the middle inputs and the tweeter to the right outputs..pretty easy cuz on the crossover the inputs r labeled S+/- which is the woofer and T+/- for the tweeter and i believe its LN+/- for the line in from the door....and problems let us kno
Bookmarks