here are some pics of the install,
Intake air temp sensor (IAT) bung tig welded in:
sanded, primed and painted pipe, installed sensor:
Manifold Absolute Pressure sensor mounted (MAP):
time to yank the ecu:
My ecu wiring is super clean, everything i've added since had become a little bit of a tangle:
pandora's box:
lets open it up:
old EPROM removed:
installing emulator cable:
easy enough:
done, ready to reinstall ecu:
damn it just looks sexy sometimes:
time to fab up the adaptor harness:
start with some new pigtails:
part i stole out of a old damaged MAS i had laying around, will be the male end of my SD harness:
solder a few connections:
time to seal it up very thoroughly:
strengthening and taking the slack out of the harness with zip ties:
then tape, then loom, then tape,
finished product:
picked up a new filter and a short piece of pipe to make a new "no recirculation bung" intake for the turbo. i forgot to take pics of it.
will put them up tomorrow
Bookmarks