ive seen rotas with a very similar design
http://www.gruppe-s.com/Advan/advanrz.htm
Hey guys I really want to find some ADVAN RS/ RZ used or replicas that look similar to these. If you guys know of any brand that has similar design please post a link to them.
Size:18s (I want the concave aggressive look)
My fenders are rolled and I am lowered.
Thanks.
ive seen rotas with a very similar design
These are pretty close
http://www.rotawheels.com/wheels.asp?wheelid=29
Found some!
Would this size work?
Rota G-Force
Front 18 x 8.5 [5 x 114.3] Offset: +48
Rear 18 x 9 [5 x 114.3] Offset: +30
or
All Four
18 x 9 [5 x 114.3] Offset: +30
What size tire would I need? would a 225/40/R18 work? I think it may have to be stretched
http://www.rotawheels.com/wheels.asp?wheelid=18
http://www.iwsti.com/forums/gd-tires...5-concave.html
Last edited by Da_silvagride; 06-17-2009 at 08:39 PM
wished they were available with 4 studs :-((((
Front 18 x 8.5 5 x 114.3 Offset +48
that will work in all four corners...9.5 is way too wide
+48 will not give that concave look tho.
pretty sure you cant get a concave face AND not have the wheels stick out WITHOUT getting fender flares.
Realy enoying with the EDM 4 studs :( Hard to find decent rims
I wanted Advan RZ's for the Galant and RS's for the Evo, but then I realized it's the most played out look ever now.
I've actually called Wheel Dude for the Rota G-Force... the only concave ones are ones with less than +35 mm offset. The rest look like shit.
Please read again. You cannot fit any Advan RS or RZ style wheel on your car and have it look good.
I have severe rubbing issues on my Galant and the fenders are rolled very aggressively. I also only drive it on occasion, so it doesn't matter much. To get the Rota G-Force +30 mm 18x9 to fit, you'd have to start cutting shit.
well put...
you will have to look into some other options if you want that concaved look and that is the only size available...basically the rule of thumb is the lower the offset you want to run, the less wide the wheel would have to be...a 9"wide wheel with a 48 offset may fit ok with only roling your fenders however a 38 offset will not work at all.
im sure there are other wheels with the same style available in a smaller width. one of my sets of wheels for example are 8.5 wide and a 36 offset. the come within about 1/4" from the ends of my fender flares. with a little negative camber they would be able to fit within the stock fenders if they are rolled well. im using this to put things in a little better perspective for you
in all honesty for a nice aggressive wheel which will hold up it will not be all that cheap. your best bet is to find a place which will allow you to buy only 1 wheel and tire and be able to return it or exchange it for a different size if it doesnt fit
Bookmarks