i already maxed out the camber plates and i dont have camber kits. AHHA
With coilovers you wont rub on 225's if you leave some negative camber in it. I have D2's with 235's 18X8 +35 offset and I dont rub up front with -2 degrees camber, the rear would have rubbed but I cut/folded the inner lip in the back. But 225's on a +38 offset wheel you wont rub on coilovers.
99' Galant ESOriginally Posted by qnz
4G64/63T
AEM EMS
i already maxed out the camber plates and i dont have camber kits. AHHA
the rears cleared after i rolled my rear fenders. but i dont know about the fronts. even though you're saying it wont rub, it still does.
welcome to the club. i rub at 3/4 turn
weird. you could try adding positive camber back in the front via the front upper mounts' camber plates... my wheels and tires are wider and i have a higher offset (meaning even less clearance to suspension) and i don't rub on the inside so the only thing i can think of is that by running full negative camber like you are, you are limiting the inside clearance allowing the tires or wheels to touch the well liner behind the wheels on steering lock... you should have ample room from the tires to the actual fender since you are running such narrow tires.
too often, but i dont regret it. i dont drive like an asshole nor do i speed. my G is automatic so driving it isnt hard, you just have to be patient. I usually map out where im going. there are some plazas and parking infrastructures that have been blacklisted because the driveways and speedbumps are too much for my car.
nice drop, it looks really good
Nobody built like u, u desighn ur self.
5spd swap
full custom body conversion
18x9 Works VS
Big 16g evo3T next project
I may just dump mine too. I wanted this look for a min. I been to scared to do it since I would have to get another alignment. I have alot of positive camber in the front. My rear sits like your rear. How is the tire wear in the front?
Hmm My megans are as low as I can get them. I have a small amount of preload on the springs and the collars are adjusted up as far as they can go and I still have a 2 finger gap :(
03 ES 5spd--Rota torque gloss black 17x8 et. 35--Hankook Ventus V12 evo 235/45/17--D2 coilovers--DC Sports STB--Intake--Brembo calipers--Powerslot Rotors--Stoptech Pads--SS brakes lines--35% tint--5k heads & 5k fogs--Alpine headunit--Kicker 400w amp--Alphasonix sub
thank god i didn't go with megans. i was going to buy megans but they were on back order.
i know it's hard to tell from my photos but im actually tucking about half of my tire in the rears and im tucking the treads in the front. then again i can't really tell from your sig how much your rears are sitting. anyways my tire wear is normal. none of them are wearing unevenly.
Bookmarks