Galant306m's turbo build

[Voodoo]

Where are you going to mount the electric supercharger?

[Galant306m]

Its already mounted

[Galant306m]

And if everythig goes as planed it should start in the next few weeks for sure

[Galant306m]

Cold side is done wireing should be wrapped up this weekend if i get the day off, going to order the rest of the crap i need to make the engine start.

This is the list for the engine to run
Fuel pump need swaping
get the fuel rail system setup
spark plugs, wires and coils need to be added
clutch slave needs to be put in with line ran
mount the water injection tank wire it up and run the nozzle
weld my downpipe and mount it
fix my muffler
do my oil lines for my turbo (using stainless steal AN fittings)
put my starter in and bat
start the car!

[4-G-rim]

Are you going to fix that "bend" on the cold siding piping right before the Tbody?

[Rizzzo29]

that was just kinda thrown together to see what piping would go where, not set in stone like that and prob will be adjusted

[Galant306m]

Yea I fixed it

[Galant306m]

Im going to shorten that pipe that goes to the tbody like 3"s and then it should be good.

[Ivory8g]

:-) can't wait to see the bumper cut and fit around that massive ic! Curious how a 7g will look with an ic as big as mine

[Shadow19]

Fuck cutting the JDM bumper for that big ass FMIC. I took my time and sucessfully mounted a smaller FMIC with 2.5'' piping. With a little creativity Mitch could have probably saved his bumper without hacking the shit out of it but to each his own. Looks sexy however. I just know that it took me 4 days to weld and make a mount for my fmic, route piping and do some very small amount of trimming to my bumper. It still looks off but the bumper needs to be re worked and fitted properly next time i take it off. Looking good mitch!

[Ivory8g]

I took my time with a dremel and a saw blade and it looks perfect. No peeled paint or anything. Measured the core of the ic and the sides of my car to the first edge of the ic and made my cuts. Not rocket science......

[Shadow19]

I took my time with a dremel and a saw blade and it looks perfect. No peeled paint or anything. Measured the core of the ic and the sides of my car to the first edge of the ic and made my cuts. Not rocket science......

Indeed it isnt rocket science. However, the vr4 7g front has NO ROOM at all to mount anything. Its all about the creativity. It took me a few hours to plan on how im going to mount then route the piping. If you look close my IC is upside down.

[Galant306m]

Got a set of four brembo calipers from a evo 9 four pot fronts and two pot rears with stainless lines FTW ill post pics later

[blue8g]

dang mitch that's legit

[M-Rod]

Yeah buddy! Pics will be of them installed already, right? ;)

[Galant306m]

Nah I'm at work and I need to make a adapter for the fronts

[M-Rod]

Something like these?
http://cgi.ebay.com/ebaymotors/DSM-E...Q5fAccessories

[Galant306m]

Perfect

[blue8g]

mitch i wanna see this.....i'm only 15 minutes away......when can i see it lol the galant'll be on the rg-rs in the next two weeks, we can fap to each other....(and our cars)

[Galant306m]

I'll text you wen I have off again