If you plan on doing this mod, just to let you know the bolts might break off in the body of the car. Be very careful doing this mod.
So In the next couple of weeks I'm going to need a rear camber kit, I'm planning on going with the "Home Depot kit", I already got the link for the bolts, but I haven't found the size of the washers I need, can anyone post a link of the necessary washers?
Thanks in advance to anyone that can help.
4g64T 5spd
If you plan on doing this mod, just to let you know the bolts might break off in the body of the car. Be very careful doing this mod.
yea as long as you use the appropriate bolt strength your fine....ebay sells the mod in the form of shims way simpler and each shim shaves off i think .25 off..and it brings the bolts it was like 15 bucks..i trust way more then some random washers
ex..
http://cgi.ebay.com/ebaymotors/00-05...s#ht_741wt_914
if you pm him he can sell you them separate even if you need more
i run this same exact setup on my eibach
Last edited by 02redgalant; 08-17-2010 at 07:10 PM
washer size will be the same as the bolt size
4g64T 5spd
to be honest no clue about the bolts... but i've running them since about early last year...I drive pretty hard around turns...etc..everythings good so far i have 2 pairs on one side\1 pair on the other
Omega how did this go? I am about to do this, probably this friday. I am sitting on -2.3 degrees left and right in rear so I am going to get as flush as I can without having a rubbing issue.
I bought just the rear kit from the seller 02redgalant posted 16 shims and the bolts, I have't installed since I lowered the car on friday and saturday, tomorrow I'm going to get the rear fenders cut a little more and try to correct as much camber as possible without rubbing, I have currently like 2-3 degrees but haven't installed the kit, I'll try to do the install this week I will post here when I'm done.
P.S. What do you guys do get the camber measured, correct it and measure it again or just measure and install the kit, since each of my shims shave .25 degrees.
Last edited by OMEGA PHX; 09-07-2010 at 01:51 AM
4g64T 5spd
UPDATE: Camber kit installed today thanks to 02redgalant for the link, I used 4 shims per bolt, so approx. 1* of camber corrected, no rubbing, everything looks good.
4g64T 5spd
Bookmarks