NOTE: The key to clearing your corners is having the right tool to get between the orange plastic piece and the clear headlight assembly. The orange lens is wedged into the corner of the headlight assembly. The only thing that holds it into place is a couple millimeters of plastic on the edges except one side. That's the side where you "PULL" the orange lens out through the blinker hole.
Here is the tool I used. You can get these from almost any hardware store for around $5. If you are unable to get one of your own, I will ship it to your door for $10.
TOOLS: 10mm socket wrench, pliers, cutters & small pry bar or "L" shaped tool.
REMOVAL OF HEADLIGHTS
------------------------------------
1st: Remove the grill (held on by 6 black plastic clips)
tip: When putting the grill back, remember to snap the black plastic clips into the grill first.</span>
2nd: Remove all 4 bulbs from the headlight assembly. (front and blinkers)
3rd: Use a 10mm socket wrench to remove the headlight bolts.
4th: Pull out the headlights.
CLEARING THE CORNERS
-----------------------------------
1st: Use a prybar or anything else to get under the orange plastic piece to pull on it until it breaks or pops out.
tip: Wrap the prybar with duct tape to prevent scratching.</span>
2nd: Brake all the pieces you can until all of it has popped out from the clear housing. (like a rattle toy)
3rd: Use the pliers and cutters to cut/brake the pieces and pull them out through the blinker socket.
DONE.
-Mike.
Bookmarks