BASICALLY....it's like wrapp'n a present, but just a 1/4 of it. Put the mesh over the plastic grille and cut it down, so there's a little over an inch on both horizontal ends. Then screw in a 8#x3/8 (small) size metal screw in the top and then mold it and stretch it to the bottom and put another screw. After that I cut a slit in each corner of the mesh and folded & molded all sides and corners. Does that make sense?Originally Posted by K h O p A r I
I'll try to get some detailed instructions out when I do it over in the next few weeks. GOOD LUCK...
Bookmarks