<-----wants to be 5spd.
hello there everybody. i wi be starting my 5 speed sawp here soon. i recently just bought an 02 stratus tranny for my 2.4l and am just needing to get some more parts. i am lookin very foward to this, but i hope its not too difficult.. any advice from any of you other swapped drivers out there?
take ur time, make sure u have everything tighten to spec, and have fun....thats about it, its pretty straight forward, and just review Gooseys tutorial on it, and u should be fine
as long as its for the 2.4L they should be the same
just remember if u use an eclipse flywheel u must use an eclipse clutch, if u use a stratus flywheel, u must use a stratus clutch
Last edited by QnzMostWanted; 07-28-2011 at 02:13 PM
Don't forget to use loctite on the flywheel bolts and pressure plate bolts.
Very valuable advice ^^^ lol
Lancer/EvolutionX Rotor Glow Paint
6g74 Forged Engine w/ hx40 turbo
Eclipse GT 5 spd swapped
Rotor Glow Galant
Daily Galant
OZ Edition Eclipse
http://cgi.ebay.com/ebaymotors/F1-ST...Q5fAccessories so could that work then?
yeah that would work, but if ur doing that way, u will need a eclipse flywheel
EDIT: hmm, that says eclipse and stratus...not sure which flywheel u would need, but i'd go with the eclipse one just to be safe
Get this or something similar:
shifter cables are a biaaatchhh.
4g64T 5spd
Those wrenches are freaking lifesavers...Been there.
yea ive heard alot about those cables being a PITA. im def goin to get one of those wrenches. and i will def keep you guys updated when my parts start rolling in and what not.. but i was thinkin.. shouldnt i get new axels too cuz in a few months imma rebuild the engine and turbo it? and is it safe to get a used flywheel?
my flywheel came in today :D idk how else to upload it on here.. so imma jus put it through my facebook..
http://www.facebook.com/media/set/?s...type=1&theater
http://www.facebook.com/media/set/?s...type=1&theater
idk if it worked or not
they aren't working
just upload them to photobucket and copy/paste the [IMG] code on your post
4g64T 5spd
http://s1138.photobucket.com/albums/...t=IMG_1721.jpg
http://s1138.photobucket.com/albums/...t=IMG_1720.jpg
being as ive never seen a flywheel before, im not sure as to this is a good, or a bad one
Copy the [IMG] code below the pic on Photobucket so they show up like this:
And about the condition, it not easy to say with just pics, is the shiny surface on the top pic flat or is it irregular, remember to take it to a machine shop they will tell you if its in good condition and if it still can be cut.
Last edited by OMEGA PHX; 08-03-2011 at 10:08 PM
4g64T 5spd
its irregular, imma take it to one sometime this weekend
Bookmarks