Pretty sure they are adhesive applied.
Hey G center I was thinking about shaving my rear emblems (the galant and the mitsu emblem) and was wondering if any knew if the rear mitsu emblem is glued on or if there's a 'peg' on the rear. In other words if I remove it will there be a hole I have to fill. Any feedbacks appreciated thanks.
Pretty sure they are adhesive applied.
Effort and courage are not enough, without purpose and direction.
Depends the 2007 rear emblem will leave a hole.
9th Generation Mitsubishi G
TGC Texas Chapter
Friends don't let friends drive stock. Ever
all G models leave holes
2002 ES i4 SOHC Mitsubishi Galant
It has 3 holes about 5/16 diameter and it also has doublesided tape e . This is for a 2006 galant .
Ok I'm assuming it would be the same for an 09.
Doublesided tape for inscriptions and holes for the logo. I shaving the logo.
I Used a heatgun on the emblem to loosen the adhesive. Be careful though that you don't melt the paint.
Yea on my Acura we used a hair dryer to loosen the glue. The more you loosen it the less sticky crap you have to take off with goo gone afterwards.
hair dryer is safer. Hair dryer > floss > goo gone. Done
2002 ES i4 SOHC Mitsubishi Galant
I took my heat gun and slowly took off the back emblems. Then i find the middle EMBLEM has two holes in the back!! ! What a mistake. This was about 2 weeks ago, i can not find a BLACK EMBLEM...the ones ive found on ebay are cheap carbon fiber black
http://cgi.ebay.com/ebaymotors/REAL-...item336a707ee2
...i think i might try them out or just go back to the OEM. Any suggestions??
PS: Anybody know the size of the back emblem that covers the holes?
Link below shows dimension of rear (trunk) DSM emblem. That ebay emblem looks like 3 diamond pcs that you put together like a puzzle. Not a one piece
i spray painted my emblem matte black and put it back on. i also spray painted the "GALANT" black and managed to turn it into "AJ" and put it back on. The chrome trim and emblem on my grill is also black now :)
Bookmarks