Installation of additional devices.

[stayer]

Again hello everyone! I plan to install the compressor in my car. For the correct settings I need to install the wideband O2 metr (next WBO2) and sensor boost. In this topic I want to talk about it. Again I apologize for my English. So, to start acquired two sensor DEPO RACING. That's the way they appear on the table The devices are manufactured in Taiwan for the japanese market.

[stayer]

You must first install themselves sensors.WBO2 I decided to install in front of the rear catalyst.Create layout and make the hole.

[stayer]

It is necessary to correctly wasted hole. The nut should firmly established [/

[stayer]

Sensor rests in the thermal cover.It is also necessary to make a hole. And set himself sensor. Wire of the sensor will go under the hood and is mounted to the engine shield.

[stayer]

Can't understand why the images are so large. Moderators, can adjust these images?

[stayer]

Sensor boost for instructions connected to the vacuum hose to the inlet manifold.But on the engine 4G69 no vacuum hoses at all. So I had to turn on a lathe that kind of detail. Together with the sensor in the kit there is a small filter. .

[stayer]

Do the hole and cut the threads in a convenient location on the manifold. . Assign a sensor in the engine shield, and connect the vacuum tube. In the future to the tube so as to enable the valve blow off

[stayer]

So the sensors are installed. Now you need to install devices in the salon. I decided to install them in front of the left rack. I do not know how to English it is called a substance, but in Russian it is called plastilin. Apply for the children's creativity. Attach the glass and замазываю the cracks of plasticine.

[stayer]

On the reverse side of the I I fasten it two screws The screws will hold the glass. And completely close the detail of a paper tape.

[stayer]

Then I use resin and glass mats. Enough place a 3 layer. After the resin dries, start the processing.

[stayer]

I have the fabric of which is covered with a torpedo. Cut pattern and glue on the glass.

[stayer]

That's the way it looks.

[stayer]

The second glass is done the same way.

[stayer]

Then connect the devices to the sensors. Now I see how it is formed of fuel-air mixture and the pressure in the intake manifold.

[stayer]

Here's another video of how it works. 12082011009
Now I am ready to set up the engine. But this is the next step. On this until the finish. Waiting for your comments. If it is someone interesting.