^Agreeing with ya!!
Distribution block or not im gonna go ahead and assume they aren't all power lines. Should have drilled not chiseled 2 separate holes with grommets.
Sent From My Rooted Galaxy Note 2 using Tapatalk
That's exactly what I'm going to do on both accounts. Dremel was fucking up (kept pulling the bit out???) and couldn't find my hole saw kit but it's going to be redone within the next week. I have a new fuse box sitting the the glovebox, just haven't had the time to fix it all up yet.
Sent from my iPhone using Tapatalk
Black Diamonds
Dipped my diamonds today... Excuse my dirt been raining a lot lately
^ car looks pretty damn clean man from what we/I can see
Just purchased my timing belt, need the tensioner, water pump, control arm bushings, motor mounts/tranny, crank seal, oil seal, other belts, yadda yadda. Hopefully it gets done before the meet. Still need tires and those damn coilovers on.
Last edited by SNWFLK; 06-27-2014 at 05:50 PM
Yeah I see that but the paint quality looks pretty good
went to the junkyard and got another HVAC and found the brackets for the dual piston calipers. Gonna try to go back next week and see if I can find a rear disc and clean set of dual calipers
02 Galant ES I4 ~ DD. JDM Kit/BBS LM Gold/D2/EvoRecaro/EGR/JL Audio/Eclipse Audio/Greddy/Injen/Project Kics/Brembos
2010 Lexus IS350c Tungsten Pearl Mica/Volk GTM/H&R Springs/F sport intake/Project Kics/Lems Shift knob
2010 Lexus IS-F Ultrasonic Blue/Volk TE37/HKS Hipermax IV GT/Ventross Kit/Lexon/JoezPerformance/Tom's/Project Kics/RR-racing tune
2009 Acura TL w/Tech package A-spec Kit/ BBS LM/Tein
Man that's a nice looking bike. I've been thinking about one a bit lately... and in white too...
Anyway today I finally reassembled the dash after driving without it for about 2 weeks to locate some rattling. Added a bunch of stick-on felt in a bunch of plates so hopefully that gets rid of the damn rattling! Also removed the spoiler because one of the threaded inserts was broken. I'm not sure if I'll try to fix the spoiler or just go without it for awhile.
Well, wasn't today, but yesterday, most of my bearing set came in, except for the thrust bearings, which are on further back order than undersized mains and standard size rod
Also last night, a distributor for the Honda, a fuel pressure regulator and upper intake manifold for the Chrysler, and a new IAC for my Galant
Just because something is old, doesn't mean you throw it away
Geordi La Forge
Did a horrible plastidip job on my chrome window trim...stuff is pretty fun tho
picked up a 5spd tranny over the weekend
^ You sir have HUGE BALLS to put that in the cabin area, THAT IS LEATHER.
15 F150 3.5 ecoboost 4x4 - daily driver
01 Galant ES V6 MT (sold)
00 Eclipse RS MT
Bookmarks