^^ OoO i likes
hmm should i leave it like this?
![]()
"DSM's, making people mechanics since 1985"
Originally Posted by polishmafia
New wheels please
So I wasn't really satisfied with the front bumper because of the lower opening. I've always wanted to do an old style VR-4 bumper but with a usdm twist. Today I had the chance. I went to the junkyard and found an old Mazda mini van and grabbed a lower plastic grille mesh, modified to fit mine and install. There was a hole on the driver side but the license plate covered it up. Now, I'm satisfied...
![]()
Last edited by G-spot; 01-19-2011 at 04:59 PM
I like it
'99 5-Speed GTZ: Forged 3.6L 6G74T 6764 E85
2017: 552whp/562wtq SBE on 19psi'02 Eclipse GT: 6G72 M/T-swapped Daily Driver'10 Endeavor: 6G75 AWD Family-mobile
I like the lower bar better, tbh. I think you just need flush foglights or something to complete the look. Or push it in farther to give it a little more "depth".
impressive
Nobody built like u, u desighn ur self.
5spd swap
full custom body conversion
18x9 Works VS
Big 16g evo3T next project
the ride is good. it bounces a little too much for my taste but i have it set at the softest to give the shocks a work out. so far no rubbing. the only time i rub is on a turn with a bad bump on the drivers side. but once i stiffen the shocks a little it should solve all that. not to mention i'm trying to find a place to roll my fenders
"DSM's, making people mechanics since 1985"
Originally Posted by polishmafia
i was lowered pretty far on the eibachs for springs. i lowered the front almost 1" more than the springs did. and the rear 1.75" more than the springs. i can lower the rear only another 1.25" and the front however much i dare go.
deff worth the $$$$$. now to let my butt hole recover and save up. then buy some more stuff
"DSM's, making people mechanics since 1985"
Originally Posted by polishmafia
Bookmarks